It doesnt support computers other than Windows including Mac and Linux.
It is compatible with Windows XP, Windows Vista, Windows 7, Windows 8, Windows 8.1 and Windows 10 computer. Whether you are running on Windows x32 Bit or Windows 圆4 Bit Computer, Rockchip Driver Assistant automatically detects it and installs the driver package automatically.
Simply follow the screen instructions to install the drivers quickly. You dont have to install the drivers manually. Rounding off, here are some iPhone Tips and Tricks, PC tips and tricks, and Android Tips and Trick that you should check out as well.It is a small driver utility that automatically installs the correct driver when you run the setup file. If you have any queries concerning any of the aforementioned steps, do let us know in the comments section below. So with this, we conclude this guide on the Rockchip Batch Flash Tool. When that is done, you may reboot your device.
While the flashing process is going, the green symbol will turn yellow and continuously blink.
To do so, click on the Upgrade button situated at the bottom.Now that the device is recognized by the Rockchip Batch Flash Tool, you could begin with the flashing part.Then as and when the Connected Device shows a green symbol, release the buttons.For some other devices, you might have to press the Volume button and while it stays pressed, press the Power button.When that is done, release the Volume Down. You should do so until the Connected Device shows a green symbol.After two seconds, release the power and volume up button, but keep pressing the volume down button.Then press and hold the Power, Volume Up, and Down button together.You now have to connect your Rockchip chipset device to the PC.Once that is done, you should see the following sections getting populated- Firmware Version, Firmware Time, Support Chip, Boot Version, and Boot-Time.Please navigate to the IMG firmware file and load it onto the tool.Then right next to the FW path field, you will see a button with three dots.Launch the tool by double-clicking on the RKBatrchTool.exe file.Now that the necessary drivers are installed, it’s time to load the firmware file to the Rockchip Batch Flash Tool.STEP 2: Load Firmware IMG file to Rockchip Batch Flash Tool The installation process will now begin, and it should be completed within a few minutes.Select the Android Bootloader Interface and click the Next button.There you will find the android_winusb file, select it and click on OK. Then click on Browse and navigate to the downloaded USB driver’s folder.Click on the Have Disk button situated at the bottom.Next up, select Show all devices and hit the Next button.On the other hand, the newer Android devices should select the Let me pick from a list of device drivers on my computer.Then click on the Browse button and if you have an older device, click on the Browse button and select the entire USB drivers folder.In the next popup that appears, select Browse my Computer for Updated Driver software.
Right-click on it and select Update Drivers.Scroll to the Other Devices section, and your device should be mentioned as Unknown or Other Device.Then connect your device to PC and search for Device manager from the Start menu.So download the drivers for your device from the above-linked post. To begin with, you will have to install the USB drivers for your device.The instructions will be given in a step-by-step manner for ease of understanding. Flashing Firmware via Rockchip Batch Flash Tool